Yamaha 2007 FZ6-NA Service Manual page 235

2. Install:
• Handlebar "1"
• Upper handlebar holders "2"
• Upper handlebar holder caps "3" (Stan-
dard)
Upper handlebar holder bolt
23 Nm (2.3 m·kg, 17 ft·lb)
A. FZ6-N/FZ6-NA/FZ6-S/FZ6-SA
B. FZ6-NHG(W)/FZ6-NAHG/FZ6-SHG(W)/
FZ6-SAHG
ECA14250
CAUTION:
• First, tighten the bolts on the front side of
the handlebar holder, and then on the rear
side.
• Turn the handlebar all the way to the left
and right. If there is any contact with the
fuel tank, adjust the handlebar position.
NOTE:
Align the match marks "a" on the handlebar
with the upper surface of the lower handlebar
holders.
3. Install:
• Throttle cables
• Right handlebar switch "1"
• Throttle grip "2"
NOTE:
Align the projections "a" on the handlebar
switch with the holes "b" in the handlebar.
4. Install:
• Brake master cylinder "1"
• Brake master cylinder holder "2"
Refer to "INSTALLING THE FRONT
BRAKE MASTER CYLINDER" on page 4-
39.
NOTE:
Align the mating surfaces of the brake master
cylinder bracket with the punch mark (right
handlebar switch side) "a" on the handlebar.
5. Install:
• Clutch lever holder "1"
4-62
HANDLEBAR