Yamaha 2007 FZ6-NA Service Manual page 101

FZ6-SA/FZ6-SAHG
1. Rear brake light switch lead
2. Rear wheel sensor lead
3. Neutral switch lead
4. ABS motor coupler
5. Fuel tank breather hose
6. Crankshaft position sensor lead
7. Right handlebar switch lead
8. O sensor lead
2
9. Bracket
10.Fuel tank drain hose
11.Hydraulic unit drain hose
12.Rear brake reservoir hose
13.Clamp
14.Brake hose holder
A. Pass the fuel tank breather hose, fuel tank
drain hose, hydraulic unit drain hose and
brake light switch lead through the guide of
the stay assembly 2.
B. Clamp the tail/brake light switch lead
together with the rear wheel sensor lead,
O sensor lead and the neutral switch lead.
2
C. To the starter motor
D. Install the right handlebar switch lead cou-
pler through the hole of the bracket 2 from
the downside.
E. Route the starter motor lead by the inner
side of the air cut-off valve hose.
F. Pass the ignition coil leads #1 and #4
through inner side of the air cut-off valve
hose, and then between the frame and
bracket 2.
G. Pass the right handlebar switch lead
through the hole located on the right side
of the frame.
H. Route the right handlebar switch lead
under the bracket 2.
I. Route the coolant reservoir tank hose
under the cover 2. Route the radiator hose
(outside) outside.
J. Route the radiator hoses (2 pieces) under
the cover 2.
K. Route the crankshaft position sensor lead
inner side of the radiator hose.
L. Pass the hydraulic unit drain hose through
the clamp of muffler stay.
Align the protrusion allowance from the
clamp with the fuel tank drain hose.
M. Pull down the mark-painted sections of the
fuel tank breather hose and fuel tank drain
hose to be lower than the clamp position of
the muffler stay. Any order to take out the
fuel tank breather hose and fuel tank drain
hose can be accepted.
N. 0–20 mm (0–0.79 in)
O. Route the O sensor lead by the outer side
2
of the vehicle as viewed from the rear tail/
brake light switch lead.
P. Clamping position should be at the center
of bend-R as shown in the illustration for
the rear brake reservoir tank hose.
Q. Insert the front wheel sensor lead between
the bosses.
R. Route the front wheel sensor lead by the
inner side of the front brake hose.
S. Pass the hose and lead through the clamp
and insert the clamp into the bracket.
T. Clamp the O
of the vehicle.
U. Outside of the vehicle
V. Attach the clamp so that the opening may
be turned to the Outside of the vehicle.
W. Clamp the brake hose and the wire part in
the rear side of the brake hose holder.
2-56
CABLE ROUTING
sensor lead to the front side
2