Yamaha 2007 FZ6-NA Service Manual page 63

Item
O sensor
2
Shift shaft spring stopper screw
Shift rod nut
Shift rod nut
Shift rod joint
Shift arm bolt
Pickup coil rotor bolt
Starter motor bolt
Neutral switch
Oil level switch bolt
Speed sensor bolt
NOTE:
• Cylinder head bolt
1 First, tighten the bolts to approximately 19 Nm (1.9 m·kg, 14 ft·lb) with a torque wrench following
the tightening order.
2 Retighten the bolts 50 Nm (5.0 m·kg, 36 ft·lb) with a torque wrench.
• Crankcase bolt (main journal)
1 First, tighten the bolts to approximately 12 Nm (1.2 m·kg, 8.7 ft·lb) with a torque wrench following
the tightening order.
2 Retighten the bolts 25 Nm (2.5 m·kg, 18 ft·lb) with a torque wrench.
3 Loosen the all bolts one by one following the tightening order and then tighten them to 27 Nm
(2.7 m·kg, 20 ft·lb) again.
• Muffler joint bolt
Retighten the bolt at 1000 km (600 ml).
• Catalyst joint bolt
Retighten the bolt at 1000 km (600 ml).
Thread
Q'ty
size
M18 1
M8 1
M6 1
M6 1
M6 1 10 Nm (1.0 m·kg, 7.2 ft·lb)
M6 1 10 Nm (1.0 m·kg, 7.2 ft·lb)
M8 1
M6 2 10 Nm (1.0 m·kg, 7.2 ft·lb)
M10 1
M6 2 10 Nm (1.0 m·kg, 7.2 ft·lb)
M6 1 10 Nm (1.0 m·kg, 7.2 ft·lb)
2-18
TIGHTENING TORQUES
Tightening torque
45 Nm (4.5 m·kg, 33 ft·lb)
22 Nm (2.2 m·kg, 16 ft·lb)
7 Nm (0.7 m·kg, 5.0 ft·lb)
7 Nm (0.7 m·kg, 5.0 ft·lb)
35 Nm (3.5 m·kg, 25 ft·lb)
20 Nm (2.0 m·kg, 14 ft·lb)
Remarks
LT
Left
thread
LT