Yamaha 2007 FZ6-NA Service Manual page 99

FZ6-S/FZ6-SHG(W)
1. Rear brake light switch lead
2. Neutral switch lead
3. Fuel tank breather hose
4. Crankshaft position sensor lead
5. Right handlebar switch lead
6. O sensor lead
2
7. Bracket
8. Fuel tank drain hose
9. Rear brake reservoir hose
A. Pass the fuel tank breather hose, fuel tank
drain hose and brake light switch lead
through the guide of the stay assembly 2.
B. Clamp the tail/brake light switch lead
together with the O
neutral switch lead.
C. To the starter motor
D. Install the right handlebar switch lead cou-
pler through the hole of the bracket 2 from
the downside.
E. Route the starter motor lead by the inner
side of the air cut-off valve hose.
F. Pass the ignition coil leads #1 and #4
through inner side of the air cut-off valve
hose, and then between the frame and
bracket 2.
G. Pass the right handlebar switch lead
through the hole located on the right side
of the frame.
H. Route the right handlebar switch lead
under the bracket 2.
I. Route the coolant reservoir tank hose
under the cover 2. Route the radiator hose
(outside) outside.
J. Route the radiator hoses (2 pieces) under
the cover 2.
K. Route the crankshaft position sensor lead
inner side of the radiator hose.
L. Pull down the mark-painted sections of the
fuel tank breather hose and fuel tank drain
hose to be lower than the clamp position of
the muffler stay. Any order to take out the
fuel tank breather hose and fuel tank drain
hose can be accepted.
M. 0–20mm (0–0.79 in)
N. Route the O sensor lead by the outer side
2
of the vehicle as viewed from the rear tail/
brake light switch lead.
O. Clamping position should be at the center
of bend-R as shown in the illustration for
the rear brake reservoir tank hose.
P. Pass the fuel tank breather hose, fuel tank
drain hose and O
2
clamp and insert them to the bracket.
Q. Clamp the O sensor lead to the front side
2
of the vehicle.
R. Outside of the vehicle.
S. Attach the clamp so that the opening may
be turned to the Outside of the vehicle.
sensor lead and the
2
sensor lead through the
2-54
CABLE ROUTING