Yamaha 2007 FZ6-NA Service Manual page 414

Diag-
nostic
code
No.
Pressure difference
(intake air pressure)
03
Intake air temperature
05
Coolant temperature
06
Vehicle speed pulse
07
Lean angle sensor
08 • Upright
• Overturned
Fuel system voltage
(battery voltage)
09
Sidestand switch
20 • Stand retracted
• Stand extended
Neutral switch
21 • Neutral
• In gear
EEPROM fault code display
• Not fault
• Fault detected
60
Item
Displays the intake air pres-
sure.
Displays the intake air tem-
perature.
Displays the coolant tempera-
ture.
0–999
0.4–1.4
3.8–4.2
Approximately 12.0
ON
OFF
ON
OFF
00
01 to 02 (Fault detection cyl-
inder)
01: #1 and #4
02: #2 and #3
• (If plural cylinders are
defective, the display alter-
nates every two seconds.)
FUEL INJECTION SYSTEM
Meter display
8-41
Checking method
Turn On the engine stop
switch, then operate the
throttle while pressing the
start switch. (If the display
value changes, the perfor-
mance is OK.)
Compare the actually mea-
sured intake air tempera-
ture with the meter display
value. (*)
Compare the actually mea-
sured coolant temperature
with the meter display
value.
Check that the number
changes (integrating) when
the rear wheels are rotated.
Remove the lean angle
sensor and incline it more
than 65 degrees.
Compare with the actually
measured battery voltage.
(If the battery voltage is
lower, perform recharging.)
Turn ON/OFF the Sidestand
switch.
Perform the shift operation
of transmission.
—