Yamaha 2007 FZ6-NA Service Manual page 415

Diag-
nostic
code
No.
Malfunction history code
display
• No history
• History exists
61
Malfunction history code
erasure
62 • No history
• History exists
Malfunction code reinstate
• No malfunction code
• Malfunction code exists
63
70 Control number
* If it is not possible to check the intake temperature, use the ambient temperature as reference (use
the compared values for reference).
Actuator operation table
Diag-
nostic
code
No.
30 Ignition coil #1/#4
31 Ignition coil #2/#3
Item
00
12-50 (Fault detection code)
• (If code numbers more than
one are detected, the dis-
play alternates every two
seconds to show all the
detected code numbers.
When all code numbers are
shown, the display repeats
the same process.)
00
00–17 (Memory numbers of
the fault detection)
00
Fault code 24
• (If more than one code
number is detected, the dis-
play changes every two
seconds to show all the
detected code numbers are
shown, the display repeats.)
00–255
Item
Actuates the ignition coils #1,
#4 for five times every sec-
ond.
Illuminates the engine trou-
ble warning light.
Actuates the ignition coils #2,
#3 for five times every sec-
ond.
Illuminates the engine trou-
ble warning light.
FUEL INJECTION SYSTEM
Meter display
Actuation
8-42
Checking method
—
—
To erase the history, turn
ON the engine stop switch.
—
To reinstate, set the engine
stop switch to " ".
—
Checking method
Check the spark five times.
• Connect an ignition
checker.
Check the spark five times.
• Connect an ignition
checker.