Yamaha 2007 FZ6-NA Service Manual page 276

▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
7. Turn:
• Crankshaft
(several full turns clockwise)
8. Check:
• "T" mark "a"
Make sure the "T" mark on the pickup rotor
is aligned with the crankcase mating sure
face "b".
• Camshaft sprocket match mark "c"
Make sure the match marks on the cam-
shaft sprockets are aligned with the edge of
the cylinder head "d".
Out of alignment → Adjust.
Refer to the installation steps above.
9. Tighten:
• Camshaft sprocket bolts "1"
Camshaft sprocket bolts
20 Nm (2.0 m·kg, 1.5 ft·lb)
ECA4S81017
CAUTION:
Be sure to tighten the camshaft sprocket
bolts to the specified torque to avoid the
possibility of the bolts coming loose and
damaging the engine.
10. Measure:
• Valve clearance
Out of specification → Adjust.
Refer to "ADJUSTING THE VALVE
CLEARANCE" on page 3-4.
5-15
CAMSHAFTS