Yamaha 2007 FZ6-NA Service Manual page 105

FZ6-NA/FZ6-NAHG
1. Rear brake light switch lead
2. Rear wheel sensor lead
3. Neutral switch lead
4. Hydraulic unit motor coupler
5. Fuel tank breather hose
6. Crankshaft position sensor lead
7. Throttle cables
8. Meter and left handlebar switch lead
9. Right handlebar switch lead
10.Wire harness
11.O sensor lead
2
12.Bracket
13.Fuel tank drain hose
14.Hydraulic unit drain hose
15.Rear brake reservoir hose
16.Left handlebar switch lead
17.Clamp
18.Brake hose holder
A. Pass the fuel tank breather hose, fuel tank
drain hose, hydraulic unit drain hose and
brake light switch lead through the guide of
the stay assembly 2.
B. Clamp the tail/brake light switch lead
together with the rear wheel sensor lead,
O sensor lead and the neutral switch lead.
2
C. To the starter motor
D. Install the right handlebar switch lead cou-
pler through the hole of the bracket 2 from
the downside.
E. Route the starter motor lead by the inner
side of the air cut-off valve hose.
F. Pass the ignition coil leads #1 and #4
through inner side of the air cut-off valve
hose, and then between the frame and
bracket 2.
G. Pass the throttle cable through the hole
located on the right side of the frame.
Route the throttle cable above the wire har-
ness.
H. To the sub-wire harness
I. Pass the right handlebar switch lead
through the hole located on the right side
of the frame.
J. Route the right handlebar switch lead
under the bracket 2.
K. Route the coolant reservoir tank hose
under the cover 2. Route the radiator hose
(outside) outside.
L. Route the radiator hoses (2 pieces) under
the cover 2.
M. Route the crankshaft position sensor lead
inner side of the radiator hose.
N. Pass the hydraulic unit drain hose through
the clamp of muffler stay. Align the protru-
sion allowance from the clamp with the fuel
tank drain hose.
O. Pull down the mark-painted sections of the
fuel tank breather hose and fuel tank drain
hose to be lower than the clamp position of
the muffler stay. Any order to take out the
fuel tank breather hose and fuel tank drain
hose can be accepted.
P. 0-20 mm (0-0.79 in)
Q. Route the O
of the vehicle as viewed from the rear tail/
brake light switch lead.
R. Clamping position should be at the center
of bend-R as shown in the illustration for
the rear brake reservoir tank hose.
S. Insert the front wheel sensor lead between
the bosses.
T. Route the front wheel sensor lead by the
inner side of the front brake hose.
U. Pass the hose and lead through the clamp
and insert the clamp into the bracket.
V. Clamp the O
of the vehicle.
W. Outside of the vehicle
X. Attach the clamp so that the opening may
be turned to the outside of the vehicle.
Y. To the sub-wire harness.
Z. Pass the right handlebar switch lead
through the hole on the right side of the
frame. Route it under the inside of the
throttle cable and wire harness.
AA.Clamp the brake hose and the wire part in
the rear side of the brake hose holder.
2-60
CABLE ROUTING
sensor lead by the outer side
2
sensor lead to the front side
2