Yamaha 2007 FZ6-NA Service Manual page 97

FZ6-NHG(W)/FZ6-NAHG
1. Left handlebar switch lead
2. Main switch and immobilizer lead
3. Clutch cable
4. Wire harness
5. Throttle cables
6. Right handlebar switch lead
7. Handlebar
8. Headlight stay
A. Clamp the right handlebar switch lead and
handlebars. Point the tip of the clamp
downward in front of the handlebar.
B. Connect the lead to the meter.
C. 5 mm (0.20 in) or less
D. To the sub-wire harness
E. To the left handlebar switch lead
F. Route the branched lead behind the main
switch and immobilizer lead.
G. Pass the main switch lead immobilizer
lead, left handlebar switch lead and clutch
cable in order through the frame hole from
the lower side of the vehicle.
H. To the headlight and wire harness
I. Pass the right handlebar switch lead and
throttle cable, clutch cable through the
opening section of the headlight stay.
J. Install the clamp in the direction as shown
in the illustration.
K. Route the main switch lead and immobi-
lizer lead, left handlebar switch lead clutch
cable by the inside of the headlight stay.
2-52
CABLE ROUTING