Solid-State Drive - HP ELITE x2 1012 G1 Maintenance And Service Manual

Solid-state drive

Description
Solid-state drive
128 GB SATA-3 TLC
180 GB SATA-3 TLC
180 GB SATA-3 self-encrypting drive OPAL2
256 GB SATA-3 TLC
256 GB SATA-3 self-encrypting drive OPAL2
256 GB PCIe-3x4 NVMe
512 GB SATA-3 TLC
IMPORTANT:
and replacement.
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Keyboard (select products only) (see
b. Back cover (see
c. Display panel (see
d. Touch controller board (see
e. WLAN module (see
Remove the solid-state drive:
1. Remove 1 Phillips M2.0x2.0 screw (1).
38 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Make special note of each screw and screw lock size and location during removal
Back cover on page
Display panel on page
Touch controller board on page
WLAN module on page
Keyboard (select products only) on page
30)
31)
33)
34)
Spare part number
844862-001
844863-001
844864-001
844865-001
844866-001
844868-001
844867-001
29)