Solid-State Drive - HP Elite x2 1013 G3 Maintenance And Service Manual

Solid-state drive

Description
1 TB, PCIe, TLC
512 GB, PCIe, self-encrypting drive (SED), Opal 2, TLC
512 GB, PCIe, TLC
256 GB, PCIe, self-encrypting drive (SED), Opal 2, TLC
256 GB, PCIe, TLC
256 GB, PCIe
128 GB, SATA-3, TLC
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Display panel (see
b. Disconnect the battery cable (see
Remove the solid-state drive:
▲ Using a PH Type #0 Phillips screwdriver, remove the Phillips M1.6x1.6 screw (1), and then remove the
solid-state drive (2).
IMPORTANT:
Reverse this procedure to replace the solid-state drive.
38 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Display panel on page
Battery on page
Be sure to use the correct size screwdriver to avoid stripping the screw.
33)
36)
Spare part number
L31368-001
L31366-001
L31372-001
L31369-001
L31370-001
L31371-001
L31367-001