Group Paging Rtp Settings - Mitel 6863i Administrator's Manual

Mitel 6800i Series SIP Phone Release 4.0.0 SP2 Administrator Guide
7. The "Auto-Answer" field is enabled by default. The automatic answering feature is turned
on for the IP phone for answering Intercom calls. To disable this field, uncheck the box.
Note: If the Auto-Answer field is not checked (disabled), the phone treats the
incoming intercom call as a normal call.
8. The "Microphone Mute" field is enabled by default. The microphone is muted on the IP
phone for Intercom calls made by the originating caller. To disable this field, uncheck the
box.
9. The "Play Warning Tone" field is enabled by default. If "Auto-Answer" is enabled, the
phone plays a warning tone when it receives in incoming intercom call. To disable this field,
uncheck the box.
10. The "Allow Barge In" field is enabled by default. If an active line on the phone receives
an incoming intercom call, the active call is put on hold and the phone automatically answers
the incoming intercom call. To disable this field, uncheck the box.
11. Click Save Settings to save your changes.

GROUP PAGING RTP SETTINGS

An Administrator or User can configure a specific key (softkey, programmable key, or expansion
module key) on the phone that allows you to send/receive a Real Time Transport Protocol
(RTP) stream to/from pre-configured multicast addresses without involving SIP signaling. This
is called Group Paging on the IP phones. You can specify up to 5 listening multicast addresses.
An Administrator can use the following parameters in the configuration files to set Group Paging
RTP Settings:
• paging group listening
• softkeyN type, topsoftkeyN type, prgkeyN type, or expmodX keyN type
• sofkeyN label
• softkeyN value, topsoftkeyN value, prgkeyN value, or expmodX keyN value
An Administrator or User can use the following parameters in the Mitel Web UI to set Group
Paging RTP Settings:
• Paging Listen Addresses (Path: Basic Settings->Preferences->Group Paging RTP
Settings)
• <Paging> Key (Operation->Softkeys and XML, Programmable Keys, or Expansion
Module Keys)
Note: The Group Paging RTP Settings are dependent upon the setting for the "Allow
Barge In" parameter.
HOW IT WORKS
After pressing a configured "Paging" key on the phone, the phone sends an RTP stream to a
preconfigured multicast address (IP port). Any phone in the local network then listens for the
RTP stream on the preconfigured multicast address (IP port). For both sending and receiving
5-96