Dynaudio AIR 15 Reference Manual page 93

Error message Explanation
"!" The "!" indicates that the monitor is not connected to the network. The volume
(e.g. as "96 kHz Center!") is then automatically set to -50 dB for this monitor.
"+" The "+" indicates that this monitor is the System Controller.
(e.g. as "96 kHz L Front+")
>> A-Input Lo << This message is displayed in analog setups only. It indicates that the input
level has been detected to be between -60 dB and -20 dB for a period longer
than 3 minutes. This is a hint to turn up the Analog Input Sensitivity parameter
– see "Setup menu ► Analog input sensitivity" on page 25.
>> A-Input Hi << This message is displayed in analog setups only. It indicates that an input
level near 0 dB has been detected (peaks in 2 seconds above -1 dB). This
is a warning and you should reduce Analog input sensitivity accordingly. See
"Setup menu ► Analog input sensitivity" on page 25.
>> PSU error << This message is displayed if the power supplies fails. The power will be
turned off and the monitor cannot operate. In this case, get in touch with
support. See "Service" on page 5.
<Locked> This message is displayed when a parameter is locked by AIR Control soft-
ware and cannot be changed. Use AIR Control software to unlock parame-
ters. See "AIR Control software" on page 66.
Standby This message is displayed when no input signal above -65 dB has been de-
tected for more than 30 minutes. The amplifier is turned off. Standby mode is
released as soon a signal level above -65 dB has been detected.
>> Power save << This message is displayed when no signal has been detected on all net-
worked monitors for more than 2.5 hours. Power is turned off. Exit this mode
by pressing any key on the System controller or adjusting the volume from
the AIR Remote.
Dynaudio Professional AIR reference manual – 2014-09-28
Error messages
90