Dynaudio AIR 15 Reference Manual page 30

Parameters available for all AIR monitors
Parameter Range / values
Pink Noise On/Off
Calibrate -6 dB to +6 dB
Rel. Lev -40 dB to 0 dB
Room Position Neutral / Wall / Corner / Console / C. Wall
(Console Wall) / C. Corn (Console Corner)
Bass -6 dB to +6 dB
Treble -6 dB to +6 dB
Fig. 11: Parameters available for all AIR monitors
Parameters for AIR BASE subwoofers
Parameter Range / values
Pink Noise On/Off
Calibrate -18 dB to +6 dB
Rel. Lev. – -40 dB to 0 dB
(Relative Level)
LFE Low Pass On/Off
LFE Gain -6 to +8 dB
Polarity 0 / 180º
Phase 0 to 180°
Fig. 12: Parameters for AIR BASE subwoofers
Dynaudio Professional AIR reference manual – 2014-09-28
Explanation
Level calibration of the selected monitor
Relative preset volume for the selected monitor
Bass adjustment for the selected monitor
Treble adjustment for the selected monitor
Explanation
Level calibration of the selected monitor.
Preset volume for the selected monitor relative to the calibrated and
global volume.
Brick wall Limiter on the LFE channel attenuating frequencies above
120 Hz.
With this parameter you can boost the acoustic gain of the LFE
channel.
If the Subwoofer is correctly placed, setting the Polarity parameter
to 180º should result in a full phase cancellation at the set crossover
frequency. If this is not the case, the Delay parameter should be
adjusted.
Use this parameter to time-compensate if the subwoofer is not placed
according to the ITU 775 recommendations. There are individual
Phase settings for each of the Bass Management Cross-over
frequencies. Once set, these are stored as Global settings.
AIR Menu structure and parameters
27