5.1 setup with Digital AES/EBU card
5.1 setup with Digital AES/EBU card
Slave
Left
Master
Left
surround
Fig. 21: This illustration shows how to connect 5.1 digital setup with optional bass management.
Dynaudio Professional AIR reference manual – 2014-09-28
LS + RS
L + R
C + LFE
Master
Slave
Center
Right
System Ctrl.
Sub
Subwoofer
Slave
Right
surround
Understanding and using this setup
This setup requires...
one Master monitor with the optional Digital AES/
►
EBU Input Card installed,
four Slave monitors (or Masters set as Slave) and
►
one subwoofer.
►
Audio signals are represented by solid lines.
►
TC link signals are represented by dashed lines.
►
The Center monitor is set as the System Controller
►
by setting the TC Link button on the rear panel to
the "out" position.
The Center monitor receives all six channels on its
►
three AES/EBU connections.
The monitor's Digital IN connection receives the
►
Center and LFE signals.
The digital input No. 2 on the I/O card receives the
►
left signal and the right signal.
The digital input No. 3 on the I/O card receives the
►
left surround signal and the right surround signal.
The right, left, left surround and right surround
►
monitor and the subwoofer receive their signal
via TC LINK RJ-45 connections from the Center
Master monitor.
A clock signal must be sent over the AES connec-
►
tion feeding the Center/LFE channels (or via BNC).
With no bass management, only the LFE signal is
►
fed to the Sub.
With bass management activated, low-frequency
►
information is extracted from the five main chan-
nels below the set crossover frequency and fed to
the subwoofer.
The AIR Remote or a computer running the AIR
►
Control software (both optional) can be connected
to any available TC LINK Out connection.
AIR setups
40