5.3 setup – digital
L + LS
Master
Left
Sub
Left
subwoofer
Slave
Left
surround
Fig. 18: This illustration shows how to connect a digital 5.3 setup.
Dynaudio Professional AIR reference manual – 2014-09-28
5.3 setup – digital
C + LFE
R + RS
Master
Slave
Center
Right
System Ctrl.
Sub
Sub
Center
Right
subwoofer
subwoofer
Slave
Right
surround
Understanding and using this setup
Audio signals are represented by solid lines.
►
TC link signals are represented by dashed lines.
►
The center monitor (C) is set as the System
►
Controller by setting the TC Link button on the rear
panel to the "out" position.
The left monitor receives both the left and left sur-
►
round input signals.
The right monitor receives both the right and right
►
surround input signals.
The left surround monitor is fed via the TC LINK
►
RJ-45 connection from the left monitor.
The right surround monitor is fed via the TC LINK
►
RJ-45 connection from the right monitor.
The center monitor (C) receives both center and
►
LFE channels.
The LFE monitor receives audio via the RJ-45
►
connection from the center monitor.
With bass management off, the left and right sub-
►
woofers will receive no signal.
With bass management on, ...
►
low-frequency information is extracted from the
►
left and left surround signals and fed to the left
subwoofer.
low-frequency information is extracted from the
►
right and right surround signals and fed to the
right subwoofer.
low-frequency information is extracted from the
►
center signal, summed with the LFE channel
and fed to the center subwoofer.
The AIR Remote or a computer running the AIR
►
Control software (both optional) can be connected
to any available TC LINK Out connection.
AIR setups
36