Preferences Page - Dynaudio AIR 15 Reference Manual

Preferences page

Fig. 45: AIR Control software – Global – Preferences
Page
Use the Preferences page in the Global section of the
AIR Control software to configure certain global fea-
tures of your AIR system and access various Reset
features.
Storing the Master volume
To have your AIR monitor system store and recall the
last used master volume level when it is switched off
and on again, click the Store Master Volume button.
Locking the front keyboards of
your AIR Master monitors
To lock the front keyboards of your AIR Master moni-
tors, click the Lock Front KBD button.
For each of the remaining functions, select the respec-
tive field. This will assign it to the large slider on the
right of the window. Drag the slider to set the parameter.
Dynaudio Professional AIR reference manual – 2014-09-28
AIR Setup
Use the AIR setup parameter to specify the setup for
your AIR system. Clicking this parameter field will show
a drop-down menu.
Make sure to have your monitors connected exactly as
required for the selected setup. For more information,
see "AIR setups" on page 29.
Fig. 46: AIR Setup selection
Backlight
Use the Backlight parameter to set the backlight of your
AIR Master monitor(s) display(s) on or off.
Units
Use the Units parameter to set the unit for the delay
parameter either to meters or inches.
Port:
If your computer has multiple Com ports, set the Port
parameter to the port your are using for connection to
your AIR system.
AIR Control software
BNC Sync
Switch BNC Sync on or off. See "Setup menu ► Exter-
nal clock setup" on page 24.
A. Sensitivity
Use the A(nalog) Sensitivity parameter to set the input
of the analog input in dB.
Sleep Mode
Use the Sleep Mode parameter to set the time until the
monitors of your AIR system go into power save mode
after no signal has been detected.
Standby Mode
Use the Standby Mode parameter to set the time until
the monitors of your AIR system go into standby mode
after no signal has been detected.
Fore more information, see "Standby, Power Save
mode and powering down your AIR system" on page
12.
Reset procedures
Click one of the three buttons in the lower half of the
window to execute the respective Reset procedure.
please note that the Reset will occur immediately, so
make sure that this is what you want.
For a description of Reset procedures, see "Reset pro-
cedures" on page 87.
76