6.1 setup – analog
LS
RS
CS
R
L
Fig. 20: This illustration shows how to connect an analog 6.1 setup.
Dynaudio Professional AIR reference manual – 2014-09-28
6.1 setup – analog
L
R
C
LFE
L
R
L
R
Master
Master
Left
Center
System Ctrl.
Sub
Subwoofer
Master
Master
Center
Left
surround
surround
Slave
Right
Slave
Right
surround
Understanding and using this setup
Audio signals are represented by solid lines.
►
TC link signals are represented by dashed lines.
►
The left monitor is set as the System Controller by
►
setting the TC Link button on the rear panel to the
"out" position.
The left monitor receives both the left and right
►
input signals.
The right monitor receives audio via the TC-LINK
►
RJ-45 connection from the left monitor.
The center monitor (C) receives both the center
►
and LFE channels.
The LFE monitor receives audio via the RJ-45
►
connection from the center monitor.
The left surround monitor (LS) receives both the
►
left and right surround channel signals.
The right surround monitor receives audio via the
►
TC-LINK RJ-45 connection from the left surround
monitor.
The center surround monitor receives only the
►
center surround signal.
Center Chain: Starting with AIR software version
►
1.10, it is possible to connect one or more Center
Chain monitors.
With no bass management, only the LFE signal is
►
fed to the subwoofer.
With bass management activated, low-frequency
►
information from the five main channels is extract-
ed below the set crossover frequency and sent to
the subwoofer, where it is summed with the LFE
channel.
The AIR Remote or a computer running the AIR
►
Control software (both optional) can be connected
to any available TC LINK Out connection.
Channels must be connected as follows:
►
Left channel to the left input on the left monitor.
►
AIR setups
38