Stereo setup with chains on left and right
Stereo setup with chains – digital or analog
L + R
Master
Left
System Ctrl.
Sub
Left
Chain
Fig. 22: This illustration shows how to connect a stereo setup with chains on Left and Right.
Dynaudio Professional AIR reference manual – 2014-09-28
AES or analog signal
Slave
Right
Sub
Right
Chain
Understanding and using this setup
Audio signals are represented by solid lines.
►
TC link signals are represented by dashed lines.
►
The two chained monitors are fed with the same signal
as the two front monitors (left and right). This is the kind
of setup you would use when you want to alternate be-
tween a set of main and nearfield monitors.
The left monitor is set as the System Controller by
►
setting the TC Link button on the rear panel to the
"out" position.
The left monitor receives both the left and right
►
input signals.
The right monitor receives audio via the TC-LINK
►
RJ-45 connection from the left monitor.
The AIR Remote or a computer running the AIR
►
Control software (both optional) can be connected
to any available TC LINK Out connection.
Other "Chained" Setups
Starting with software version 1.10, the available set-
ups with "chain" option are: 5.1, 6.1 and 5.3 for analog
and digital as well as 5.1/6 master (digital only).
The installed option card will limit the choices of setups
presented on the speakers. If the AES/EBU option card
is installed, the default digital input will become Input 1
on the option card.
AIR setups
41