6.1 setup – digital – 192 kHz
LF + RF
LS + RS
Fig. 25: This illustration shows how to connect a digital 6.1 setup.
Dynaudio Professional AIR reference manual – 2014-09-28
6.1 setup – digital – 192 kHz
C + Sub
Master
Master
L
C
System Ctrl.
Sub
Sub
CS
Master
Master
LS
CS
Slave
R
Slave
RS
Understanding and using this setup
Audio signals are represented by solid lines.
►
TC link signals are represented by dashed lines.
►
This is a 6.1 digital setup with optional bass manage-
ment. This setup requires...
four Master monitors with the optional Digital I/O
►
card installed,
two Slave monitors (or Masters set as slaves) and
►
one subwoofer.
►
The left monitor is set as the System Controller by
►
setting the TC Link button on the rear panel to the
"out" position.
The left monitor receives the left and right front
►
channel signals.
The right monitor receives its signal via the TC
►
LINK cable.
The left surround monitor receives both the left and
►
right surround signals.
The center monitor receives the center channel
►
and the subwoofer signal.
The subwoofer receives its signal via the TC LINK
►
RJ-45 connection from the center Master monitor.
A clock signal must be sent over the AES connec-
►
tion feeding the Center/LFE channels (or via BNC).
With no bass management, only the LFE signal is
►
fed to the Sub.
With bass management activated, low-frequency
►
information is extracted from the six main chan-
nels below the set crossover frequency and fed to
the subwoofer, where it is summed with the LFE
channel.
The AIR Remote or a computer running the AIR
►
Control software (both optional) can be connected
to any available TC LINK Out connection.
AIR setups
45