Stereo setup with two subwoofers – digital or analog
Dynaudio Professional AIR reference manual – 2014-09-28
Stereo setup with 2 subs – digital or analog
L + R
AES or analog signal
Master
Left
System Ctrl.
Sub
Left
subwoofer
Fig. 15: This illustration shows how to connect a stereo setup with two subwoofers.
Slave
Right
Sub
Right
subwoofer
Understanding and using this setup
Audio signals are represented by solid lines.
►
TC link signals are represented by dashed lines.
►
The left monitor is set as the System Controller by
►
setting the TC Link button on the rear panel to the
"out" position.
The left monitor receives both the left and right
►
input signals.
The right monitor and the subwoofers receive
►
audio via the TC-LINK RJ-45 connection from the
left monitor.
With no bass management, no signal is sent to the
►
subwoofers.
With bass management activated, low-frequency
►
information is extracted from the left and right
channels below the set crossover frequency.
Low-frequency information from the left channel
is sent to the left subwoofer, and low-frequency
information from the right channel is sent to the
right subwoofer.
The AIR Remote or a computer running the AIR
►
Control software (both optional) can be connected
to any available TC LINK Out connection.
AIR setups
33