7.1 setup – analog or digital
L sur.
R sur.
L B. + R B.
Fig. 23: This illustration shows how to connect an analog or digital 7.1 setup
Dynaudio Professional AIR reference manual – 2014-09-28
7.1 setup – analog or digital
L + R
C + LFE
Master
Master
Left
Center
System Ctrl.
Sub
Subwoofer
Master
Slave
Left
Right
surround
surround
Master
Left
Back
Slave
Right
Slave
Right
Back
Understanding and using this setup
It is not possible to choose a 7.1 setup in the setup
menu. You need to choose either a 5.1 or 6.1 setup and
set up the Left surround and Right surround speakers
for "L Inner" and "R Inner" tasks respectively.
Audio signals are represented by solid lines.
►
TC link signals are represented by dashed lines.
►
Digital connections
The center monitor is set as the System Controller
►
by setting the TC Link button on the rear panel to
the "out" position.
The left monitor receives both the left and right
►
input signals. The right monitor is fed via the TC
LINK RJ-45 connection from left to right.
The center monitor receives both the Center and
►
LFE signals. The LFE monitor is fed via the TC
LINK RJ-45 connection from Center to LFE.
The left surround monitor receives both the left sur-
►
round and right surround signals.
The right surround monitor is fed via the TC LINK
►
RJ-45 connection from left surround to right sur-
round.
The left back monitor receives both the left back
►
and the right back signal. The right back monitor
is fed via the TC LINK RJ-45 connection from left
back to right back.
With bass management activated, low-frequency
►
information is extracted from the five main chan-
nels and fed to the subwoofer, where it is summed
with the LFE channel. With bass management
activated, low-frequency information is not extract-
ed for the left and right inner monitors.
The AIR Remote or a computer running the AIR
►
Control software (both optional) can be connected
to any available TC LINK Out connection.
AIR setups
42