5.1 Setup - Analog - Dynaudio AIR 15 Reference Manual

5.1 setup – analog
LS RS
R
L
Fig. 17: This illustration shows how to connect a 5.1 analog setup.
Dynaudio Professional AIR reference manual – 2014-09-28
5.1 setup – analog
L R C LFE
L R L R
Master Master
Left Center
Sytem Ctrl.
Sub
Subwoofer
Master
Left
Surround
Slave
Right
Slave
Right
Surround
Understanding and using this setup
Audio signals are represented by solid lines.
►
TC link signals are represented by dashed lines.
►
The left monitor is set as the System Controller by
►
setting the TC Link button on the rear panel to the
"out" position.
The left monitor receives both the left and right
►
input signals.
The right monitor receives audio via the TC-LINK
►
RJ-45 connection from the left monitor.
The left surround monitor (LS) receives both the
►
left and right surround channel signals.
The right surround monitor receives audio via the
►
TC-LINK RJ-45 connection from the left surround
monitor.
The center monitor (C) receives both center and
►
LFE channels.
The LFE monitor receives audio via the RJ-45
►
connection from the center monitor.
With no bass management, the subwoofer will play
►
only the LFE channel.
With bass management activated, low-frequency
►
information from the five main channels is extract-
ed and sent to the subwoofer, where it is summed
with the LFE channel.
The AIR Remote or a computer running the AIR
►
Control software (both optional) can be connected
to any available TC LINK Out connection.
AIR setups
35