Ecb Controller Replacement - Vision Fitness X20 Service Manual

7.15 Ecb controllEr rEplacEMEnt

1) remove the side covers as outlined in Section 7.12.
2) the eCB controller should be at the maximum resistance level with no power. this means that the eCB controller wire should be at the 8
o'clock position (Figure A). If necessary, power on the unit, up the resistance on the console to level 20, and then remove power.
3) Use a screwdriver to remove the tension from the eCB controller wire by pushing the orange plate to the left (Figure B).
figUrE a
4) with the tension removed from the eCB controller wire, it can be removed from the eCB controller spool (Figure C).
5) remove the electrical connection from the eCB controller (Figure D).
figUrE c
48
cHaptEr 7: part rEplacEMEnt gUiDE
figUrE b
figUrE D