Vision Fitness X20 Service Manual page 61

cHaptEr 8: Elliptical trainEr SpEcificationS anD aSSEMbly gUiDE
8.2 aSSEMbly inStrUctionS - continUED
HarDWarE Kit for StEp 5
inclUDES:
M8 x 72mm oval hex Socket Bolt - Qty 2
M8 x 20mm oval hex Socket Bolt - Qty 2
M8 nylon nut - Qty 2
8 x 15 x 2.0t Spring washer - Qty 4
16 x 28 x 1.0t teflon washer - Qty 4
8 x 20 3.0t Flat washer - Qty 4
20 x 27 x 1.5t Flat washer - Qty 2
20 x 29 x 0.5t wavy washer - Qty 2
StEp 5
1) open the hardware bag for Step 5.
2) Attach the link arms.
a. Slide a wavy washer and a 27mm flat washer onto the link arm before sliding the link arm onto the pedal arm bracket.
b. Attach the link arm to the pedal arm using 1 flat washer, 1 spring washer and 1 bolt.
c. Align the opposite end of the link arm with the bracket on the bottom of the lower handlebar.
d. Place teflon washers on both sides of the link arm. while holding the teflon washers, slide the link arm into the bottom end of the lower
handlebar.
e. Secure the joint with 1 bolt, 1 flat washer, 1 spring washer, and 1 nut.
f. repeat on the opposite side.
3) Attach the side pedal covers.
a. Attach the side pedals covers with 2 pre-attached screws on each side.
57