Vision Fitness X20 Service Manual page 62

cHaptEr 8: Elliptical trainEr SpEcificationS anD aSSEMbly gUiDE
8.2 aSSEMbly inStrUctionS - continUED
StEp 6
1) open the hardware bag for Step 6.
2) Attach the upper handlebars. .
a. Slide the handlebar boot over the bottom of the upper handlebar.
b. Slide the upper handlebar onto the lower handlebar and align the notch with the tab making sure that the handlebars are joined together
completely.
c. repeat on the opposite side.
3) Attach the top cap.
a. Slide the top cap over the console mast and carefully snap into place.
b. Carefully insert the console mast boot over the top cap, snapping the tabs closest to the console mast first, then the other two tabs.
4) X20 onlY
a. Attach the cup holder using 2 pre-attached screws.
58
HarDWarE Kit for StEp 6 inclUDES:
M10 x 12mm Set Screw - Qty 4