cHaptEr 7: part rEplacEMEnt gUiDE
7.13 DriVE bElt rEplacEMEnt
1) remove the side covers as outlined in Section 7.12.
2) loosen the 2 large nuts holding the eCB tightly to the frame (Figure A).
3) loosen the 2 eye bolt nuts putting tension on the belt (Figure B).
figUrE a
figUrE b
4) once the eCB is no longer held tightly to the frame, push up on the eCB. this will release the tension on the belt allowing you to remove it
from the drive axle pulley (Figure C).
5) once the belt is removed from the drive axle pulley, slide the eCB towards the front of the unit and out of the frame. this will allow the drive
belt to be removed from the eCB pulley (Figure D).
6) reverse Steps 1-5 to install a new drive belt.
46