Vision Fitness X20 Service Manual page 59

cHaptEr 8: Elliptical trainEr SpEcificationS anD aSSEMbly gUiDE
8.2 aSSEMbly inStrUctionS - continUED
HarDWarE Kit for StEp 3
inclUDES:
M8 x 20mm oval hex Socket Bolt - Qty 2
17 x 23 x 0.5t wavy washer - Qty 2
8 x 20 x 1.5t Flat washer - Qty 2
8 x 15 x 2.0t Spring washer - Qty 2
StEp 3
1) open the hardware bag for Step 3.
2) Attach the pedal arms.
a. Slide a wavy washer over the crank followed by the pedal arm as shown. rest the pedal arm wheel on the guide rail.
b. Attach the pedal arm to the crank using 1 flat washer, 1 spring washer, and 1 bolt.
c. repeat on the other side.
3) Attach the console mast.
a. tie a wire to the data cable and feed the connectors through the console mast.
b. Make sure that the data cable is not pinched between the console mast and the console mast bracket.
c. Slide the console mast over the 4 bolts in the console mast bracket.
d. tighten the 4 bolts in the console mast bracket.
4) Attach the pedal arm covers.
a. Make sure the holes are on the bottom of the pedal arm.
b. Attach the bottom cover first with the 2 screws pre-attached to the cover. Snap the top cover into place.
c. repeat on the opposite side.
55