7.15 Ecb controllEr rEplacEMEnt - continUED
6) remove the 4 screws holding the eCB controller to the frame (Figure e).
7) remove the eCB controller from the frame (Figure F).
figUrE E
8) reverse Steps 1-7 to install a new eCB controller. NOTE: the eCB controller wire should be set so that the eCB controller wire is at 8
o'clock. After setting the eCB controller wire to the correct position, tighten the nut and sleeve on the wire so that they are tight (Figure G).
9) test the elliptical trainer for function. NOTE: when the resistance level is at 1, the eCB controller wire should be at about 4 o'clock (Figure
h). .
figUrE g
cHaptEr 7: part rEplacEMEnt gUiDE
figUrE f
figUrE H
49