7.12 ecb (electRonic bRaKe) ReplaceMent
1) remove the front shrouds as outlined in section 7.1.
2) Disconnect the ECB wire harness at the lower control board (Figure a).
3) Cut the tie straps holding the ECB wire harness to the frame (Figure B).
fiGuRe a
4) Disconnect the ECB wire harness and the cable housing at the ECB adjustment box (Figures C & D).
fiGuRe c
cHapteR 7: paRt ReplaceMent GuiDe
fiGuRe a
fiGuRe a
fiGuRe b
fiGuRe D
37