7.4 HanDlEbar rEplacEMEnt
1) remove the bolt / nut holding the handlebar to the link arm (Figure A).
2) remove the screw holding the handlebar to the rotational housing on the console mast (Figure B).
figUrE a
3) the handlebar can now be removed.
4) Install a new handlebar onto the console mast rotational housing. NOTE: Make sure that a flat washer and wavy washer are installed on
the rotational housing prior to installing the new handlebar (Figure C).
5) Attach the new handlebar to the link arm. NOTE: Be sure to re-install the teflon washers between the link arm and the handlebar (Figure
D).
figUrE c
34
cHaptEr 7: part rEplacEMEnt gUiDE
figUrE b
figUrE D