Vision Fitness X20 Service Manual page 63

cHaptEr 8: Elliptical trainEr SpEcificationS anD aSSEMbly gUiDE
8.2 aSSEMbly inStrUctionS - continUED
StEp 7
1) Attach the console.
a. with the screwdriver, remove the 4 console mast screws from the back of the console. Connect the heart rate wires coming from the
console mast to the heart rate wires coming out of the back of the console. Plug the data cables into the board. Pull any extra wiring down into
the console mast. Secure the console to the console mast using the 4 console mounting screws removed earlier. tighten with the screwdriver.
b. Plug the power cord into the power socket in the front of the unit. Plug the other end of the power cord into the wall outlet. Make sure
the power switches on the bottom of the unit and on the back of the console are in the on position.
tHE HarDWarE nEEDED for
StEp 7 iS prE-attacHED to
tHE partS
59