Filling A Barrel; Run The Barrel Motor; Rinsing A Barrel - Cornelius VIPER 2 FLAVOR Service Manual

Filling a Barrel

Run the Barrel Motor

Rinsing a Barrel

© 2008-2012, IMI Cornelius Inc.
Step Action
1
Fill a barrel
2
Select the barrel
3
Select Fill function
4
Finish filling the barrel
Complete the proce-
5
dure
NOTE: When FILL button is pressed, it changes to a STOP button.
Step Action
1
Run a barrel
2
Select the barrel
3
Select Run function
4
Stop the procedure
NOTE: When RUN button is pressed, it changes to a STOP button.
When rinsing a barrel, the Barrel Maintenance menu cannot be used. The
procedure must be done manually, as described in Table 23.
Step Action
1
Empty a barrel
2
Rinse a barrel
3
Select the barrel
4
Turn off the barrel
- 37 -
Table 21
Procedure
From the Select menu (Figure 25), open the Barrel
Maintenance menu, shown in Figure 26.
Use the Up and Down arrows to highlight the
desired barrel
Press the FILL button at the bottom of the display
to fill the highlighted barrel
When the fill completes, intermittently open and
close the relief valve to bleed CO
Press the STOP button at the bottom of the display
to stop the fill. Press the BACK button to return to
the Select menu.
Table 22
Procedure
From the Setup menu (Figure 25), open the Barrel
Maintenance menu, shown in Figure 26.
Use the Up and Down arrows to highlight the
desired barrel
Press the SPIN button at the bottom of the display
to start the motor in the highlighted barrel
Press the STOP button at the bottom of the display
to stop the motor. Press the BACK button to return
to the Select menu.
Table 23
Procedure
If the barrel has liquid in it, use the Purge proce-
dure in Table 20 to empty the barrel.
Go to the Barrel Status menu (Figure 12).
Use the Up and Down arrows to highlight the
desired barrel
Press the OFF button at the bottom of the display
to turn off the barrel.
Publication Number: 621260373SER
Viper Service Manual
from the barrel.
2