Cleaning The Water Filter - Cornelius VIPER 2 FLAVOR Service Manual

Cleaning the Water Filter

© 2008-201, IMI Cornelius Inc.
The water filter screen in the rear of the unit should be removed and cleaned
every six months, during the preventative maintenance procedures. To inspect
and clean the filter screen, perform the procedure in Table 42.. Refer to Figure
39 for water filter location.
Water
Filter
Figure 39. Water Filter Location
Step
1.
Disconnect power from the unit.
2.
Turn off and disconnect the water supply to the unit.
3.
Remove the rear cover of the unit.
4.
Disassemble the water filter. (Use two wrenches, if necessary)
5.
Remove the filter and rinse it under running water to remove any debris.
6.
Reassembe the filter.
7.
Connect and turn on the water supply to the unit.
8.
Check the filter for any leaks.
9.
Replace the rear cover.
10.
Reconnect power to the unit.
- 58 -
Viper Service Manual
Table 42.
Procedure
Publication Number: 621260373SER