Cornelius VIPER 2 FLAVOR Service Manual page 48

© 2008-2012, IMI Cornelius Inc.
the calibration procedure on that motor. This procedure correlates the actual
viscosity of the barrel and its contents with the electrical characteristics of the
motor. These characteristics are stored by the control system and are accessed at
the time of calibration for each particular motor.
Because of the differences between motor characteristics from different motor
suppliers, the Motor menu, shown in Figure 33, is used to adjust the unit settings
to match the motor type being installed. It provides the correct table of electrical
characteristics from imbedded settings located in non-volatile memory. Perform
the procedure described in Table 29 to change the motor type setting. Insure that
the motor type matches the settings listed in Table 27 based on model.
NOTE: If the Motor Type shown is "DEFAULT", it indicates that the
EEPROM is not installed or is faulty.
Model
All 60 Hz
All 50 Hz
#1 MOTOR TYPE 1
MOTOR
#2 MOTOR TYPE 2
SETUP
12:51P
MAR 04
BACK CAL ‐ +
Button
BACK Returns the display to the Select menu
CAL Verifies the motor settings of a new motor.
- Decrements the highlighted field
+ Increments the highlighted field
Step Action
Set barrel for Motor
1
Type
2 Select the barrel
Select the proper
3
motor type
Complete the proce-
4
dure
- 43 -
Table 27
Figure 33. Motor Setup Screen
Table 28
Description
Table 29
From the Maintenance menu (Figure 25), open the
Motor Setup menu, shown in Figure 33.
Use the Up and Down arrows to highlight the
desired barrel
Press the + or - buttons at the bottom of the dis-
play to select the proper motor type
Press the BACK button at the bottom of the display
to save the settings and return to the Setup menu.
Publication Number: 621260373SER
Viper Service Manual
Motor Type
1
2
Procedure