Security Log - AudioCodes MP-202 User Manual

MP-202 Telephone Adapter
8. Under the screen section 'QoS Operation', set rule priority with Quality of Service by
checking the check box (to add a priority to the rule); the screen refreshes (refer to the
figure), allowing you to select between one of eight priority levels, zero being the
lowest and seven the highest (each priority level is mapped to low/medium/high
priority). This sets the priority of a packet on the connection matching the rule, while
routing the packet.
9. Check the check box 'Set DSCP' to mark a DSCP value on packets matching this rule;
the screen refreshes (refer to the figure), allowing you to enter the hexadecimal value
of the DSCP.
10. Under the screen section 'Logging', check the parameter 'Log Packets Matched by
This Rule' to log the first packet from a connection that was matched by this rule.
11. By default, the 'Schedule' rule will always be active. However, you can configure
scheduler rules in order to define time segments during which the rule may be active.
12. Click 'OK' to save the settings.
12.8

Security Log

The Security log displays a list of firewall-related events, including attempts to establish
inbound and outbound connections, attempts to authenticate at an administrative interface
(Web-based management or Telnet terminal), firewall configuration and system start-up.
User's Manual
Figure 12-28: Set Priority Rule
Figure 12-29: Set DSCP Rule
163
12. Security
February 2007