AudioCodes MP-202 User Manual page 125

MP-202 Telephone Adapter
3. Open menu Advanced > Remote Administration. Check the check boxes 'Using
Primary HTTP Port (80)' and 'Allow Incoming ICMP Echo Requests' (to allow HTTP
and ICMP from the WAN interface)
4. For data, configure VLAN ID 300 and then configure it to 'Obtain IP Address
Automatically' (refer to the figure below) (optionally, you can use a static IP address).
5. For VOIP, configure VLAN ID 200 and then configure it to 'Obtain IP Address
Automatically' (optionally, you can use a static IP address).
6. For management, configure VLAN ID 400 and then configure it to 'Obtain IP Address
Automatically' (optionally, you can use a static IP address). The figure below shows
how to obtain DHCP on the interface.
User's Manual
Figure 10-33: Network Connections
Figure 10-34: Configuring WAN Ethernet
125
10. VLAN and Bridge Settings
February 2007