Table 10-1: Vlan Interface - General Communication Parameters - AudioCodes MP-202 User Manual

MP-202 Telephone Adapter

Table 10-1: VLAN Interface - General Communication Parameters

Parameter
Schedule
Network
Physical Address
Clone MAC
MTU
Underlying Connection
Select one of the following Internet Protocol options from the 'Internet Protocol' drop down
menu:
No IP Address
Obtain an IP Address Automatically
Use the Following IP Address
Note that according to the selection you make in the 'Internet Protocol' drop down menu,
the screen will refresh and display relevant configuration settings.
User's Manual
Description
By default, the connection will always be active.
However, you can configure scheduler rules in
order to define time segments during which the
connection may be active. Once a scheduler
rule(s) is defined (via Advanced>Scheduler
Rules), this field changes to a combo box,
allowing you to choose between the available
rules. To configure scheduler rules, refer to
Section 10.11.
Select whether the parameters you are
configuring relate to a WAN, LAN or DMZ
connection, by selecting the connection type from
the combo box. For detailed information, refer to
Section 4.2.
The physical address of the network card used for
your network. Some cards allow you to change
this address.
Allows you to copy the current MAC address of
your PC to the MAC address of this device.
MTU is the Maximum Transmission Unit. It
specifies the largest packet size permitted for
Internet transmission. In the default setting,
Automatic, the Telephone Adapter selects the
best MTU for your Internet connection. In case
you change to manual, you can enter the largest
packet size, you should leave this value in the
1200 to 1500 range.
The Ethernet device that the connection is
implemented over.
105
10. VLAN and Bridge Settings
February 2007