AudioCodes MP-202 User Manual page 115

MP-202 Telephone Adapter
5. Define an IP address for each device and click Apply and OK.
Changing the Routing Mode
To change the routing mode:
1. (For all VOIP packets needing to be transferred within the VoIP VLAN) Open menu
Network Connections > WAN Ethernet 2 > Settings; the figure shown below opens.
2. In the Routing drop-down list, change the mode to 'Advanced'; extended parameters
are displayed (refer to the figure below).
Figure 10-20: Routing - Advanced - Extended Parameters
3. Configure parameter 'Routing Mode' (NAT or Route). Choose 'Route' and check the
check box 'Default Route' in order to use the VoIP VLAN.
4. Configure 'Device Metric' to be the lower than the default metric (default = 3).
User's Manual
Figure 10-19: Routing - Advanced
115
10. VLAN and Bridge Settings
February 2007