TP-Link JetStream T2700G-28TQ User Manual page 335

Auth Port:
Auth Key:
Accounting Config

Accounting:
Primary IP:
Secondary IP:
Accounting Port:
Accounting Key:
Note:
1. The 802.1X function takes effect only when it is enabled globally on the switch and for the port.
2. The 802.1X function cannot be enabled for LAG member ports. That is, the port with 802.1X
function enabled cannot be added to the LAG.
3. The 802.1X function should not be enabled for the port connected to the authentication server.
In addition, the authentication parameters of the switch and the authentication server should be
the same.
Configuration Procedure:
Step Operation
1 Connect an authentication
server to the switch and do
some configuration.
2 Install the 802.1X client
software.
3 Configure
globally.
4 Configure the parameters of
the authentication server
5 Configure the 802.1X for the
port.
Set the UDP port of authentication server(s). The default port is 1812
Set the shared password for the switch and the authentication
servers to exchange messages.
Enable/Disable the accounting feature.
Enter the IP address of the accounting server.
Enter the IP address of the alternate accounting server.
Set the UDP port of accounting server(s). The default port is 1813.
Set the shared password for the switch and the accounting
servers to exchange messages.
Description
Required. Record the information of the client in the LAN to
the authentication server and configure the corresponding
authentication username and password for the client.
Required. For the client computers, you are required to
install the 802.1X software TpSupplicant provided on the
CD. For the installation guide, please refer to
802.1X Client
the 802.1X Required. By default, the global 802.1X function is disabled.
On the Network Security→802.1X→Global Config page,
configure the 802.1X function globally.
Required. On the Network Security→802.1X→Radius
Server page, configure the parameters of the server.
Required. On the Network Security→802.1X→Port
Config page, configure the 802.1X feature for the port of
the switch basing on the actual network.
Software.
323
Appendix C:
Return to CONTENTS