TP-Link JetStream T2700G-28TQ User Manual page 16

Chapter
Chapter 8 Spanning Tree
Chapter 9 Multicast
Chapter 10 Routing
Chapter 11 Multicast Routing
Introduction
This module is used to configure spanning tree function of the
switch. Here mainly introduces:
STP Config: Configure and view the global settings of

spanning tree function.
Port Config: Configure CIST parameters of ports.

MSTP Instance: Configure MSTP instances.

STP Security: Configure protection function to prevent devices

from any malicious attack against STP features.
This module is used to configure multicast function of the switch.
Here mainly introduces:
IGMP Snooping: Configure global parameters of IGMP

Snooping function, port properties, VLAN and multicast VLAN.
Multicast IP: Configure multicast IP table.

Multicast Filter: Configure multicast filter feature to restrict

users ordering multicast programs.
Packet Statistics: View the multicast data traffic on each port of

the switch, which facilitates you to monitor the IGMP messages
in the network.
Querier: Configure the switch to act as an IGMP Snooping

Querier.
The module is used to configure several IPv4 unicast routing
protocols. Here mainly introduces:
Interface: Configure and view different types of interfaces:

VLAN, loopback and routed port.
Routing table: Displays the routing information summary.

Static Routing: Configure and view static routes.

DHCP Server: Configure the DHCP feature to assign IP

parameters to specified devices.
DHCP Relay: Configure the DHCP relay feature.

Proxy ARP: Configure the Proxy ARP feature to enable hosts

on the same network but isolated at layer 2 to communicate
with each other.
ARP: Displays the ARP information.

RIP: Configure the RIP feature. RIP is an interior gateway

protocol using UDP data packets to exchange routing
information.
OSPF: Configure the Open Shortest Path protocol.

VRRP: Configure the Virtual Router Redundant Protocol.

This module is used to configure several multicast routing
protocols for multicast data forwarding. Here mainly introduces:
Global Config:

IGMP: Configure the IGMP features.

PIM DM: Configure the PIM DM features.

PIM SM: Configure the PIM SM features.

Static Mroute: Configure the static multicast routing features.

4