TP-Link JetStream T2700G-28TQ User Manual page 258

Choose the menu Multicast Routing→PIM DM→PIM DM neighbor to load the following page.
The following entries are displayed on this screen:
PIM DM Interface Config

The L3 interfaces can be configured as PIM DM mode by this page.
Search Option:
PIM DM Neighbor

Interface:
Neighbor:
Uptime:
Expires:
Configuration Procedure for PIM DM:
Step Operation
1 Configure interface
2 Configure routing
protocol
3 Enable multicast
routing and PIM DM
Figure 11-14 PIM DM neighbor
ALL: Displays all entries.

Interface Vlan: Select Interface and enter the interface ID

of your desired entry.
Neighbor: Select Neighbor and enter the neighbor

address of your desired entry.
Interface Routed Port： Select the routed port the desired

entry must carry.
The physical interface on which PIM DM is enabled.
The IP address of the PIM neighbor for which this entry
contains information.
The time since the PIM neighbor (last) became a neighbor of
the local switch.
The time remaining before the PIM neighbor will be aged out.
Description
Required. Configure IP addresses and subnet masks of routing
interfaces on Routing→Interface→Interface Config page.
Required. Configure the routing entries via static route or dynamic
routing protocol like OSPF, and make sure all network can
communicate with each other and update the routing information
through a unicast routing protocol dynamically.
Required. Enable multicast routing on Multicast Routing→Global
Config page. Enable PIM DM on routing interfaces on Multicast
Routing→PIM DM→PIM DM Interface page.
246