TP-Link JetStream T2700G-28TQ User Manual page 107

Port Config

Unit:
Select:
Port:
Status:
Registration
Mode:
LeaveAll Timer:
Join Timer:
Leave Timer:
LAG:
Note:
LeaveAll Timer >= 10* Leave Timer, Leave Timer >= 2*Join Timer.
Configuration Procedure:
Step Operation
1 Set the link type for port.
2 Enable GVRP function.
3 Configure the registration
mode and the timers for the
port.
Select the unit ID of the desired member in the stack.
Select the desired port for configuration. It is multi-optional.
Displays the port number.
Enable/Disable the GVRP feature for the port. The port type should
be set to TRUNK before enabling the GVRP feature.
Select the Registration Mode for the port.
Normal: In this mode, a port can dynamically register/deregister
•
a VLAN and propagate the dynamic/static VLAN information.
• Fixed: In this mode, a port cannot register/deregister a VLAN
dynamically. It only propagates static VLAN information.
• Forbidden: In this mode, a port cannot register/deregister
VLANs. It only propagates VLAN 1 information.
Once the LeaveAll Timer is set, the port with GVRP enabled can send
a LeaveAll message after the timer times out, so that other GARP
ports can re-register all the attribute information. After that, the
LeaveAll timer will start to begin a new cycle. The LeaveAll Timer
ranges from 1000 to 30000 centiseconds.
To guarantee the transmission of the Join messages, a GARP port
sends each Join message two times. The Join Timer is used to define
the interval between the two sending operations of each Join
message. The Join Timer ranges from 20 to 1000 centiseconds.
Once the Leave Timer is set, the GARP port receiving a Leave
message will start its Leave timer, and deregister the attribute
information if it does not receive a Join message again before the
timer times out. The Leave Timer ranges from 60 to 3000
centiseconds.
Displays the LAG to which the port belongs.
Description
Required. On the VLAN→802.1Q VLAN→Port Config
page, set the link type of the port to be TRUNK.
Required. On the VLAN→GVRP page, enable GVRP
function.
Required. On the VLAN→GVRP page, configure the
parameters of ports basing on actual applications.
95