CYBEX Arc Trainer 425A Service Manual page 71

H. Install the back cover to the monitor (AA).
See Figure 23.
Figure 23
24. Tighten the three cable ties.
A. Pull the loose coax and power cables
through the access hole. See Figure 10.
B. Tighten the three cable ties securely.
See Figure 10.
25. Plug in AC/DC Adapter and coax cables.
A. Locate the AC/DC adapter (GG) supplied
with the monitor and plug into the power
cable exiting the base of the Arc.
B. Plug the power cord (HH) into the AC/DC
adapter (GG). NOTE: Power cord (HH)
varies by country.
C. Thread the antenna/cable source cable
(supplied at the site location) into the coax
cable exiting the base of the Arc.
26. Set up monitor for first time use.
A. Locate the Personal Entertainment Monitor
Manual (LT-20191) and follow the set up
procedure in Chapter 5.
B. Plug the power cord (HH) into a wall outlet.
C. Plug headphones (not supplied) into
headphone jack located at base of console.
D. Refer to Chapter 3 of the Personal
Entertainment Monitor Manual (LT-20191)
regarding use of the channel and volume
keys located on the lower center of the
Arc console. See Figure 24.
(AA)
Figure 24
27. Attach the lower side covers.
Back
Cover
28. Attach the upper side covers.
29. Attach the top cover.
30. Attach the front cover.
31. Attach the handes.
Channel
Keys
A. Hold the lower covers in place. See Figure 8.
B. Using a Phillips screwdriver, tighten the four
screws securing each lower side cover.
A. Place the upper covers in position. See
Figure 7.
B. Using a Phillips screwdriver, tighten the
screw securing each upper side cover.
A. Place the upper left cover in postiion. See
Figure 6.
B. Using a Phillips screwdriver, tighten the
screw securing the top cover.
A. Place the front cover in position. See Figure 5.
B. Using a Phillips screwdriver, tighten the four
screws securing the front cover.
A. Position right handle vertically and align
handle opening with mainframe opening.
See Figure 4.
B. Insert pivot shaft into mainframe and handle
openings. See Figure 4.
C. Position left handle vertically and align
handle opening with mainframe opening.
D. Push pivot shaft through opening.
E. Apply loctite (R) to the two BHSCS (removed
in step 5C) and into where they will be
threaded.
Volume
Keys