CYBEX Arc Trainer 425A Service Manual page 46

C. Remove the rear leg from the foot bar. See
Figure 4.
Rear Leg
Loctite
Figure 4
6. Remove foot bar.
A. Using a 7/32" Allen wrench, remove the
BHSCS, plastic end cap and spacer securing
the foot bar to the front leg. See Figure 5.
NOTE: Older units have an aluminum end cap
and do not have a spacer.
Front Leg
Loctite
BHSCS/
Loctite
C
D
Figure 5
B. Remove the foot bar.
7. Install new foot bar.
A. Place grease on the outside of the front leg
shaft. See Figure 5.
B. Place the new foot bar (A) or (B) into position
on the front leg.
C. Place a drop of loctite (E) on the BHSCS
and another drop inside the shaft into where
the BHSCS will be tightened.
Cybex ® and the Cybex logo are registered trademarks of Cybex International, Inc.
Arc Trainer ® and its mark are registered trademarks of Cybex International, Inc.
10 Trotter Drive Medway, MA 02053 • 508-533-4300 • FAX 508-533-5183 • www.cybexinternational.com • techhelp@cybexintl.com
techpubs@cybexintl.com • Copyright © 2008, Cybex International, Inc. All rights reserved • 425A-506 B • March 2008
Foot Bar
Grease
Grease
B
D. Using a 7/32" Allen wrench, install the
BHSCS/loctite, new plastic end cap (C)
and new spacer (D) as shown in Figure 5.
NOTE: Instead of installing these new
parts, you can reinstall the old aluminum
end cap.
E. Tighten securely.
8. Install rear leg on the new foot bar.
A. Place grease on the outside of the new
foot bar shaft. See Figure 4.
B. Place the rear leg into position on the
new foot bar.
9. Install rear leg.
A. Place grease on the pivot pin that was
removed in step 5A. See Figure 3.
B. Place the rear leg so that the pivot hole
aligns with the holes in the frame. See
Figure 3.
C. Insert pivot pin. See Figure 3.
D. Place a drop of loctite (E) on the BHSCS
removed in step 5A and another drop
inside the shaft of the pivot pin to where
the BHSCS will be tightened. See Figure 3.
E. Install the BHSCS/loctite and retainer to
the pivot pin and tighten using two 7/32"
Allen wrenches. See Figure 3.
10. Reinstall the BHSCS/loctite and end cap.
A. Place a drop of loctite (E) on the BHSCS
removed in step 4A and another drop
inside the shaft into where the BHSCS
will be tightened.
B. Using a 7/32" Allen wrench, reinstall the
BHSCS/loctite and end cap that was
removed in step 4A. See Figure 2.
C. Tighten securely.
11. Test for proper operation.