CYBEX Arc Trainer 425A Service Manual page 65

Kit No. 425AK044
NOTE: This instruction sheet describes how to install
the Cybex Personal Entertainment Monitor on
the Arc Trainer 425A.
Tools Required
• 3 mm Allen wrench
• 5/32" Allen wrench
• 7/16" Open end wrench
• Phillips screwdriver
1. Read and understand all instructions
thoroughly before installing this kit.
2. Verify kit contents shown in Figure 1.
A. Console monitor mount (1), 425A-220
B. Audio cable 1/4" to 3.5 mm 18" (1), 630A-102
C. RJ-45 round cable (1), 630A-103
D. Headphone adapter clamp (1), 630A-330
E. Headphone jack mount bracket (1), 630A-331
F. Coax and power cable I/O W/2.1 mm (1),
630A-104
G. Allen wrench 3 mm (1), BK030210
H. Adapter, 1/4 plug to 1/8 stereo jack (1),
ES000001
I. Self tapping screw 8-16 x .31 (2), HT552509
J. Self tapping screw 8-16 x .75 (2), HT552515
K. Strain relief bushing (1), PP740000
L. A/V bottom membrane (1), SW-19621-4 (NOTE:
for English Console only)
M. Cybex monitor kit (1), EE000005 or EE000007
N. Poster (1), 425A-513 (not shown)
O. Warranty sheet (1), LT-20219 (not shown)
P. Cable Tie (5), EW000028
Q. Signal Isolator (1), 425A-490
R. Loctite (1), YA000201 (not shown)
M
L
F
G
P
Figure 1
Arc Trainer
• 7/32" Allen wrench (2)
• Side cutter
• Utility knife
• Cloth
B
K
H
C
D
A
E
I
J
Q
®
425A A/V
3. Verify the monitor kit contents shown in Figure 2.
AA. Monitor (1), EE000005 or EE000007
BB. Remote control (1), EM000000
CC. Batteries, remote control, AAA size (2), N/A
DD. Screws, mounting, M4 x 0.7 x 10 mm (4),
HC692860
EE. Washers, external lock, (4), HS047300
FF. Washers, flat, M4 (4), HS097600
GG. AC/DC adapter (1), ET300038
HH. Power cord, 115 VAC 60 Hz, (Country specific
cords supplied with product), (1), EW600000
Personal Entertainment Monitor Manual (1),
II.
LT-20191
GG
Figure 2
4. Elevate the unit and disconnect the power source.
A. Elevate the unit to level 10 incline.
B. While the unit is elevated, unplug the power cord
from the power outlet.
! WARNING: Disconnect the power cord before
continuing this procedure. Keep wet
items away from inside parts of the
unit. Electrical shock could occur
even if the unit is unplugged.
NOTE: To protect paint place a cloth over upper
frame before removing handles.
5. Remove the input handles.
A. Using a 5/32" Allen wrench, remove the Button
Head Socket Cap Screw (BHSCS), washer,
end cap and spacer securing the S-link to the
input handles. See Figure 3.
Installation Instructions
AA
CC
DD
EE
BB
FF
HH
II