CYBEX Arc Trainer 425A Service Manual page 58

Coax and power cable
about 5" of cable with
female exposed for
monitors with center
connectors
Monitor
Mount
Controller
Cable
Lockwasher
(4)
BHSCS
(4)
Console
Mount
BHSCS
(3)
Figure 11
13. Attach the console mount.
A. Position the console mount (A) on the main
frame assembly and hand thread each of the
three BHSCS. See Figure 11.
B. Securely fasten the BHSCS with a 7/32" Allen
wrench.
14. Insert the coax and power cables.
A. Route the coax and power cable up through
the monitor mount until cable exits the top.
See Figure 11.
B. With 5" or 8" of coax and power cables exiting
the top of the monitor mount, pull the extra
coax and power cables out of the bottom of
the main frame. See Figure 11.
15. Insert the controller cable.
A. Route the controller cable down through the
monitor mount until the cable exits the hole in
the console mount. See Figure 12.
Coax and power cable
about 8" of cable with
female exposed for
monitors with side
connectors
Display
Console
Console
Cable
Heart Rate
Cable
Controller
Mounting
Bracket
Console, Heart
Rate, Coax and
Power Cables
16. Attach strain relief bushing.
A. Insert controller cable through the strain relief
bushing. See Figure 12.
Figure 12
B. Insert the strain relief bushing into the console
mount hole.
17. Attach the display console and contoller.
A. Connect the console and heart rate cables
(exiting the top of the console mount) to the
display console. See Figure 11.
B. Using two screws and lock washers, secure the
top of the display console to the console mount.
See Figure 11.
C. Attach the controller mounting bracket to
the bottom of the console mount using the
remaining two screws and lock washers. See
Figure 11.
D. Secure controller to the controller mounting
bracket with nylon ties (not included in this kit)
as recommended by the controller manufacturer.
E. Plug the controller cable connector to the
back of the controller. NOTE: Ensure cable
connectors are securely fastened.
18. Installing the Monitor.
NOTE: An assistant is required when installing the
monitor.
A. Secure monitor on the monitor bracket using
the hardware supplied with the monitor. See
Figure 13. NOTE: For monitors with center
connectors, remove the back plate from the
monitor and secure back to the mounting
bracket.
Strain Relief
Bushing
Controller
Cable
Console Mount Hole