CYBEX Arc Trainer 425A Service Manual page 68

Console Battery
Door Cover
Screw
Screws
(4)
Rear Console
Cover
Figure 12
NOTE: Step 13 is for English units only, all other
languages skip to step 14.
13. Replace bottom membrane with A/V membrane.
A. Using a Phillips screwdriver, remove the three
screws securing the main display PC board
to the front console cover. See Figure 13.
Screw
Figure 13
B. Unplug the bottom membrane ribbon cable
from the the main display PC board. See
Figure 14.
Figure 14
C. Using a utility knife, pry off bottom membrane
from the front console cover. See Figure 15.
Ribbon Cable
Bottom
Membrane
A/V
Membrane
Figure 15
D. Peel off backing from new A/V membrane
and place on the front console cover.
See Figure 15.
E. Plug the A/V membrane ribbon cable into
the main display PC board. See Figure 14.
F. Using a Phillips screwdriver, reattach the
three screws securing the main display PC
board to the front console cover. See
Figure 13.
14. Install audio cable, bracket, clamp and
adapter to front cover.
A. Using a Phillips screwdriver, attach the two
screws (I) securing the headphone jack
mount bracket (E). See Figure 16.
B
I
D
J
PART OF B
Figure 16
B. Attach the audio cable (B) to the headphone
jack mount bracket (E) securing it with the
flat washer and nut (attached to cable). See
Figure 16.
C. Attach the adapter (H) securing it in place
with the headphone adapter clamp (D) and
two screws (J). See Figure 16.
Cybex International, Inc. Medway, MA USA (508) 533-4300 www.CybexInternational.com Wireless HR Receiver Inside
end
.
. .
.
. . .
. .
E
H