CYBEX Arc Trainer 425A Service Manual page 51

Kit No. 425AK013
NOTE: This instruction sheet describes how to
replace the S-Link in the Arc Trainer 425A.
Tools Required
• 5/32" Allen wrench
• Grease
1. Read and understand all instructions thoroughly
before installing this kit.
2. Verify kit contents. See Figure 1.
A
B
A. S-Link, (1), 425AK013
B. Washer, (2), HS307601
C. End Cap, (2), 425A-482
D. Spacer, (2), 600A-311
E. Loctite, (1), YA000201
Figure 1
3. Remove the S-link.
A. Using a 5/32" Allen wrench, remove each
Button Head Socket Cap Screw (BHSCS),
washer, end cap and spacer securing both
ends of the S-link. See Figure 2.
NOTE: In older units remove the BHSCS, aluminum
end cap and nylon washer. These parts can
be reinstalled rather than using the new
washer, plastic end cap and spacer.
Cybex ® and the Cybex logo are registered trademarks of Cybex International, Inc.
Arc Trainer ® and its mark are registered trademarks of Cybex International, Inc.
10 Trotter Drive Medway, MA 02053 • 508-533-4300 • FAX 508-533-5183 • www.cybexinternational.com • techhelp@cybexintl.com
techpubs@cybexintl.com • Copyright © 2008, Cybex International, Inc. All rights reserved • 425A-511 B • March 2008
Arc Trainer
C D E
®
425A S-Link
BHSCS/
Loctite
(2)
Grease
E
Front Leg
Figure 2
B. Remove the S-link.
4. Installing the new S-link.
A. Place grease on the outside of shaft. See
Figure 2.
B. Place the new S-link (A) in position. See
Figure 2.
C. Place a drop of loctite (E) to threads of each
BHSCS removed in step 3A and another drop
inside the shaft into where each BHSCS will
be tightened.
D. Install the two new spacers (D), two new end
caps (C), two new washers (B) and two
BHSCS/loctite as shown in Figure 2. NOTE:
Instead of installing these new parts you can
reinstall the old end cap and nylon washer.
E. Using a 5/32" Allen wrench, tighten both
BHSCS securely.
F. Test the unit to verify proper operation.
Installation Instructions
Handle
B
C
D
(2)
(2)
(2)
E
A
Grease