CYBEX Arc Trainer 425A Service Manual page 53

Kit No. 425AK015
NOTE: This instruction sheet describes how to install
the side handles on the Arc Trainer 425A.
Tools Required
• 7/32" Allen wrench
1. Read and understand all instructions thoroughly
before installing this kit.
2. Verify kit contents. See Figure 1.
A. Left side handle (1), 425A-217
B. Right side handle (1), 425A-218
C. BHSCS .375-16 x .75 blk zinc (8), HS-60531
D. Loctite #242, YA000201
D
B
Figure 1
3. Install the handles.
A. Using a 7/32" Allen wrench, remove the
outside four Button Head Socket Cap
Screw (BHSCS) securing the left rear leg
to the frame. See Figure 2.
Cybex ® and the Cybex logo are registered trademarks of Cybex International, Inc.
Arc Trainer ® and its mark are registered trademarks of Cybex International, Inc.
10 Trotter Drive Medway, MA 02053 • 508-533-4300 • FAX 508-533-5183 • www.cybexinternational.com • techhelp@cybexintl.com
techpubs@cybexintl.com • Copyright © 2008, Cybex International, Inc. All rights reserved • 425A-493 A • March 2008
®
Arc Trainer
A
C
425A Side Handles
Loctite
Figure 2
B. Place a drop of loctite (D) on the four new
BHSCS (C). Place another drop of loctite in
the threaded hole where each BHSCS will
be tightened into.
C. Install the left side handle using the four
BHSCS/loctite. Tighten the four BHSCS
securely. NOTE: Install the handle bracket
so that the bend of the handle is toward
the front. Figure 2.
D. Repeat steps 3A through 3C to install the
right side handle.
E. Test the unit to verify proper operation.
Installation Instructions
NOTE: The bend of the handle
is toward the front.
Left Side
Handle
BHSCS/
Loctite
(4)